Your name or email adress:
Do you already have an account?
Forgot your password?
  • Log in or Sign up

    • PCB Supplies Product Slider

      Drilling Bits
      End Mills


      PCB Materials

      Health and Safety

    • Articles RSS Feed

      Article Preview

      This is Table of IPC-2221 (Generic Standard on Printed Board Design), which lists the minimum spacing between conductors for various conditions such as internal vs. external, coated vs. uncoated, high or low altitude, and traces vs. component leads

      Grounding Strategies for Printed Circuit Boards

      Design and layout of a printed circuit board (PCB) for electromagnetic compatibility (EMC) is probably the most cost-effective measure possible in the quest for EMC compliance. It is cost-effective because it requires no additional components. It requires just the knowledge of EMC layout methods and experience in applying them. ...
      Article Preview

      Mitsubishi NanoBenefit 3G Series Silver Nano Ink and Silver Nano Inkjet Media can be used to produce printed circuits utilising standard inkjet printers and refillable inkjet cartridges the Ink cost is around $200 per a bottle (100 ml), a printer is about $80, and empty cartridges are $10. A bottle of the ink may cover over than 10 m2.
      Article Preview

      Eco-friendly circuit board releases its electronics when exposed to hot water. Scientists from the UK’s National Physical Laboratory (NPL) have developed a printed circuit board that falls apart when immersed in hot water. ...
      Article Preview

      250ml Polypropylene Tri-Pour Beaker

      Graduated from 20ml to 250ml.
      Height: 90mm.
      Diameter: 47mm - 76mm.
      Tricorner beakers provide three ...
      Article Preview

      3M Scotch-Brite Hand Pads

      Scotch-Brite 7448 Grey SULFN: Ultra fine pad for light finishing on all minerals as well as lacquer de-nibbing. ...
      Published on 22nd November 2013 14:14
      Article Preview

      3585 ULTRAWIPE Ultra Low Lint Dry Wipes

      Superb grade of high wet and dry strength, high weight, ultra low lint fabric makes this wipe ...
      Article Preview

      When in house prototypeing, flexible PCB's are often seen as unviable, because of the lack of readily available laminates. (If you wish, ...

      This drill size chart provides a list of standard size drill bits in several measurement systems, including fractional, metric, wire gauge number, and letter. The decimal equivalents of the diameters are shown in both English and Metric units. Fractional sizes are measured in inches, while metric sizes are measured in millimeters. The wire gauge and letter systems refer to tool diameters that increase as the wire gauge decreases from #107 to #1 and then continues from A to Z.
      Article Preview

      Other issues:
      Rings that fit too tightly may crack and loosen catastrophically.
      Rings that have protruding material (“flash”) on the inside diameter ...
      Article Preview

      The copper in a PCB is rated in ounces, and represents the thickness of 1 ounce of copper rolled out to an area of 1 square foot. For example a PCB that uses 1 oz. copper has a thickness of 1.4mils.
      Article Preview

      How fast I can cut without breaking a bit?

      If you are primarliy cutting metal, in most cases, the process of selecting the proper speed (RPM) and feed-rate is relatively straightforward. If you are cutting woods or plastics, its not so easy. Nonetheless, it is possible to arrive at an optimum combination of speed and feed reliably and repeatably without experiencing too much brain-death.

      The following discussion assumes that:

      • SPEED always refers to spindle RPM
      • FEED always refers to how fast the cutter moves

    • Welcome Unregistered

      • If this is your first visit, and you are not registered already, please click the register link below to proceed. Register