Your name or email adress:
Do you already have an account?
Forgot your password?
  • Log in or Sign up

    • PCB Supplies Copper Board Slider
      #slideshow-1 #slideshow-3 #slideshow-5 #slideshow-7 #slideshow-10
      1 2 3 4 5 6 7 8 9 10

      Routers

      We supply SC Series Chipbreaker Routers ranging from 0.5mm diameter to 3.0mm diameter

      Routers

      The Chipbreaker Geometry with an updraft design reduces swarf and debris build up.

      Routers

      Our Routers feature fishtail tips to eliminate splintering

      Routers

      Our SC Series reduces burrs creating cleaner, sharper holes

      Routers

      Distance rings can be set at either any distance for you

      Routers

      We supply SC Series Chipbreaker Routers ranging from 0.5mm diameter to 3.0mm diameter

      Routers

      The Chipbreaker Geometry with an updraft design reduces swarf and debris build up

      Routers

      Our Routers feature fishtail tips to eliminate splintering

      Routers

      Our SC Series reduces burrs creating cleaner, sharper holes

      Routers

      Distance rings can be set at either any distance for you

    • Router Overview





      PCB Supplies supplies the highest of quality Routers manufactured by Union Tools. These Routers are made of top quality Tungsten Carbide.

      We hold stock of SC Series Routers; these Routers have a right hand, up draft design which lifts debris upwards out of the hole being drilled rather than allowing it to fall into the hole causing the bit to bind and break. These Routers also feature a chip-breaker geometry, this chops the swarf into smaller parts and helps to reduce the radial load on the spiral flute this reducing bird nesting and binding and general wear producing more accurately cut, cleaner edged holes.

      The SC Series Routers are suitable for peripheral contour routing. And this series have a beneficial effect on burr reduction.

      The life of the router is dependent on a number of factors including feed rate, speed, material characteristics, and what the user considers acceptable milling quality. Due to the brittleness of carbide these drill bits are recommended for use with drill presses or precision equipment. Care must be taken not to drop or flex them as breakage may occur.

      Features

      • Common 3.15mm 1/8" shanks
      • Solid carbide drill element
      • Designed for high speed equipment operating up to 80,000 RPM
      • Can be used at lower speeds by using a slower feed rate


      We recommend that bits are fitted with depth setting rings. This will allow you to set the plunge depth stop on your drill press to a single value that will work for all bit diameters.
      All of our bits can be purchased with or without rings. When ordering drills with depth rings, you may specify the depth ring position to suit your requirements.